taking out a brass screw from an aluminium alloy case why did they put brass in there i will never know not a good mix that i now know after a little reading and thinking back to the metal chemistry days cathodes and corrosion makes it really hard to take out or loosen o tighten real problems should never had touched it none of this undo too far and then tr to go back and then breaking the bastard going to the hand file pull it all out drill out and do the best to put a thread back in or clean the thread and make a new wrong screw fit and never to touch it again and put that housing back on tight and sealed i can already see so many places where this is going horribly wrong again still i never suspected such a poor choice in materials i just wanted to do the job as it was conceived to be done i am still kicking myself dont worry we are not yet in so much trouble that i cannot get parts here on the ranch we are still getting them and still replacing them and eventually i will get it right i can barley do the tasks i am doing and i would rather not go down these optionally routes of learning the song is called crazy for you but the lyrics are crazy for loving you
all works presented herein are 'threewords' with the exception of reposted videos duly titled.